Pioneer FH-P80BT User Manual download pdf (Page 35)

When you select YES, this unit changes to

PH BOOK DOWNLOAD and the download op-

eration automatically begins. After complet-

ing, DATA DOWNLOADED is displayed.

According to the circumstances, this unit

changes to PH BOOK TRANSFER. In this case,

refer to step 4 on Transferring entries to the

phone book on page 43.

# When you select NO, the display reverts to

normal.

Using this unit to initiate a connection

1 Display the connection menu.

Refer to Introduction to connection and pairing

on page 33.

2 Use MULTI-CONTROL to select

BT HANDS FREE.

3 Use MULTI-CONTROL to select a group.

Push MULTI-CONTROL up or down to select a

group.

NOKIA (Nokia)—STANDARD (standard)

# Normally select STANDARD. If the device of

Nokia is not paired to this unit, select NOKIA.

# Push MULTI-CONTROL left or right to display

a group name or an ID.

4 Press MULTI-CONTROL to switch to

PAIR FROM PHONE.

Push MULTI-CONTROL up or down to switch

PAIR FROM PHONE and SEARCH DEVICE.

5 Select SEARCH DEVICE and then press

MULTI-CONTROL to start searching.

While searching, SEARCHING is displayed.

# If this unit fails to find any available cellular

phones, NOT FOUND is displayed.

6 Use MULTI-CONTROL to select a device.

Push MULTI-CONTROL up or down to select a

device name you want to connect.

Press MULTI-CONTROL to select a device

name.

# Push MULTI-CONTROL left or right to switch

the BD address and device name.

7 Use your cellular phone to establish

connection.

PIN code is set to 0000 as the default. You can

change this code in the initial setting. Refer to

Entering PIN code for Bluetooth wireless con-

nection on page 56.

While connecting, CONNECTING is displayed.

If the connection is established, COMPLETED

is displayed.

After connected, this unit automatically

changes to PH.BOOK DL (phone book down-

load confirmation) display.

# If the connection fails, ERROR is displayed. In

this case, check the cellular phone and try again.

# If three cellular phones have already been

paired, the pairing assignment selection display

will appear. Select one assignment to pair the

new phone. The newly paired phone overwrites

the previously paired phone. The assignment se-

lection operation is the same as Step 3 to 4 of

Pairing a connected cellular phone on the next

page except for the operation below.

! Switching the BD address and device name

8 Use MULTI-CONTROL to decide to

download the phone book from your cellu-

lar phone or not.

Push MULTI-CONTROL left or right to select

NO (No) or YES (Yes).

Press MULTI-CONTROL to decide.

When you select YES, this unit changes to

PH BOOK DOWNLOAD and the download op-

eration automatically begins. After complet-

ing, DATA DOWNLOADED is displayed.

According to the circumstances, this unit

changes to PH BOOK TRANSFER. In this case,

refer to step 4 on Transferring entries to the

phone book on page 43.

# When you select NO, the display reverts to

normal.

Connecting a paired cellular phone

1 Display the connection menu.

Refer to Introduction to connection and pairing

on page 33.

Operating this unit

En

35

Section

02

Operating this unit

1 ... 34 35 36 ... 77

Comments to this Manuals

No comments