Pioneer FH-P80BT User Manual download pdf (Page 36)

2 Turn MULTI-CONTROL to select

PAIRED PHONE.

# Push MULTI-CONTROL up or down to select a

desired phone.

# Push MULTI-CONTROL left or right to display

the BD address, group and ID number.

3 Press MULTI-CONTROL to start connec-

tion.

PIN code is set to 0000 as the default. You can

change this code in the initial setting. Refer to

Entering PIN code for Bluetooth wireless con-

nection on page 56.

While connecting, CONNECTING is displayed.

If the connection is established, CONNECTED

is displayed.

After connected, this unit automatically

changes to PH.BOOK DL (phone book down-

load confirmation) display.

# If the connection fails, ERROR is displayed. In

this case, check the cellular phone and try again.

4 Use MULTI-CONTROL to decide to

download the phone book from your cellu-

lar phone or not.

Push MULTI-CONTROL left or right to select

NO (No) or YES (Yes).

Press MULTI-CONTROL to decide.

When you select YES, this unit changes to

PH BOOK DOWNLOAD and the download op-

eration automatically begins. After complet-

ing, DATA DOWNLOADED is displayed.

# When you select NO, the display reverts to

normal.

Disconnecting a cellular phone

1 Display the connection menu.

Refer to Introduction to connection and pairing

on page 33.

2 Use MULTI-CONTROL to select

DISCONNECT PHONE.

3 Press MULTI-CONTROL to disconnect a

cellular phone from this unit.

After disconnection is completed,

DISCONNECTED is displayed.

Pairing a connected cellular phone

Pairing is usually performed automatically dur-

ing the connection operation. You only need to

perform this operation manually when your

phone is connected temporarily for any reason.

We recommend you pair the phone to this unit

to make best use of the technology.

1 Display the connection menu.

Refer to Introduction to connection and pairing

on page 33.

2 Use MULTI-CONTROL to select

SET PHONE.

3 Push MULTI-CONTROL up or down to

select a pairing assignment.

P1 (user phone 1)—P2 (user phone 2)—P3

(user phone 3)

# Push MULTI-CONTROL left or right to switch

the BD address and device name.

# If a phone is already assigned to the user

phone number, the new phone will overwrite the

old one.

# As you select each assignment, you can see

whether or not a phone is already paired. If the

assignment is empty, NO DATA is displayed.

4 Press MULTI-CONTROL to pair the cur-

rently connected phone.

When pairing is completed, COMPLETED is

displayed.

# If the pairing fails, REGISTER ERROR is dis-

played. In this case, return to step 1 and try

again.

Deleting a paired phone

1 Display the connection menu.

Refer to Introduction to connection and pairing

on page 33.

2 Use MULTI-CONTROL to select

DELETE PHONE.

Operating this unit

En

36

Section

02

1 ... 35 36 37 ... 77

Comments to this Manuals

No comments