Pioneer AVIC-X3-II User Manual download pdf (Page 25)

Reset the navigation system to

the initial (factory) setting

When you want to erase memorised settings

and return the navigation system to its initial

(factory) settings, carry out the following op-

erations.

1 Turn the engine ON or set the ignition

switch to ACC position.

2 Press RESET button with a pen tip or

other pointed instrument.

p Some navigation settings and data are not

erased.

DVD Map Discs for Your

Navigation System

Configuration of data recorded

on discs

The map for this navigation system is supplied

on three discs; for the west, for the central,

and for the east. Please set the disc to use ac-

cording to your destination or current location.

The areas recorded on each disc are as fol-

lows:

West area disc East area disc

Central area disc

p Removing the disc and inserting other disc

causes the navigation system to automati-

cally restart and reload the new route. (This

automatic “Reroute” operation cannot be

cancelled.)

Initial Use

If the initial learning is not complete, following

screen appears.

% If a message appears, touch [OK].

When the navigation system begins running

for the first time, the 3D Hybrid Sensor auto-

matically begins initial learning. Positioning is

performed solely by GPS satellites until the 3D

Hybrid Sensor initial learning is complete, so

the location of your vehicle may not be very ac-

curate. This is not an error. When the initial

learning is complete, the location of your vehi-

cle can be detected with high accuracy.

p [Shop Demo] is the demonstration used in

a store. Do not touch [Shop Demo].

= If an error message appears during initial

learning, refer to Messages and how to

react to them on page 135.

Introduction

Engb

25

Chapter

01

Introduction

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 171 172

Comments to this Manuals

No comments