Pioneer DEH-P510UB User Manual download pdf (Page 26)

+6 to –6 is displayed as the level is increased

or decreased.

# You can then select another band and adjust

the level.

5 Press BAND/ESC to cancel the 7-band

graphic equalizer adjustment.

Adjusting loudness

Loudness compensates for deficiencies in the

low- and high-sound ranges at low volume.

1 Use MULTI-CONTROL to select

Loudness in the audio function menu.

Refer to Introduction of audio adjustments on

page 24.

2 Press MULTI-CONTROL to turn loudness

on.

Loudness level (e.g., Mid) appears in the dis-

play.

# To turn loudness off, press MULTI-CONTROL

again.

3 Push MULTI-CONTROL left or right to

select a desired level.

Each time MULTI-CONTROL is pushed lef t or

right, level is selected in the following order:

Low (low)—Mid (mid)—High (high)

Using subwoofer output

This unit is equipped with a subwoofer output

which can be turned on or off.

1 Press SW/BASS to display the subwoo-

fer setting mode.

Press SW/BASS repeatedly to switch between

the subwoofer setting modes in the following

order.

SubWoofer1 (subwoofer on/off setting) set-

ting mode—SubWoofer2 (subwoofer setting)

setting mode

2 Select SubWoofer1 setting mode.

3 Press MULTI-CONTROL to turn subwoo-

fer output on.

Normal appears in the display. Subwoofer out-

put is now on.

# To turn subwoofer output off, press

MULTI-CONTROL again.

4 Push MULTI-CONTROL left or right to

select the phase of subwoofer output.

Push MULTI-CONTROL left to select reverse

phase and Reverse appears in the display.

Push MULTI-CONTROL right to select normal

phase and Normal appears in the display.

Note

You can also switch to this setting mode in the

menu that appears by using MULTI-CONTROL.

Adjusting subwoofer settings

When the subwoofer output is on, you can ad-

just the cut-off frequency and the output level

of the subwoofer.

Only frequencies lower than those in the se-

lected range are outputted from the subwoo-

fer.

! When the subwoofer output is on, you can

select SubWoofer2.

1 Press SW/BASS to display the subwoo-

fer setting mode.

Press SW/BASS repeatedly to switch between

the subwoofer setting modes in the following

order.

SubWoofer1 (subwoofer on/off setting) set-

ting mode—SubWoofer2 (subwoofer setting)

setting mode

2 Select SubWoofer2 setting mode.

3 Push MULTI-CONTROL left or right to

select cut-off frequency.

Each time MULTI-CONTROL is pushed lef t or

right, cut-off frequencies are selected in the

following order:

50Hz—63Hz—80Hz—100Hz—125Hz

Audio Adjustments

En

26

Section

03

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 217 218

Comments to this Manuals

No comments