Pioneer DEH-P510UB User Manual download pdf (Page 27)

4 Push MULTI-CONTROL up or down to

adjust the output level of the subwoofer.

Each time MULTI-CONTROL is pushed up or

down, subwoofer level increases or decrease s.

+6 to -24 is displayed as the level is increased

or decreased.

Note

You can also switch to this setting mode in the

menu that appears by using

MULTI-CONTROL.

Boosting the bass

Bass boost function boosts the bass level of

sound.

1 Press and hold SW/BASS to display Bass

setting mode.

2 Push MULTI-CONTROL up or down to

select a desired level.

0 to +6 is displayed as the level is increased or

decreased.

Note

You can also switch to this setting mode in the

menu that appears by using

MULTI-CONTROL.

Using the high pass filter

When you do not want low sounds from the

subwoofer output frequency range to play

from the front or rear speakers, turn on the

HPF (high pass filter). Only frequencies higher

than those in the selected range are output

from the front or rear speakers.

1 Use MULTI-CONTROL to select HPF.

Refer to Introduction of audio adjustments on

page 24.

2 Press MULTI-CONTROL to turn high

pass filter on.

80Hz appears in the display. High pass filter is

now on.

# If the high pass filter has been previously ad-

justed, the frequency of that previously selected

will be displayed instead of 80Hz.

# To turn high pass filter off, press

MULTI-CONTROL again.

3 Push MULTI-CONTROL left or right to

select cut-off frequency.

Each time MULTI-CONTROL is pushed lef t or

right, cut-off frequencies are selected in the

following order:

50Hz—63Hz—80Hz—100Hz—125Hz

Adjusting source levels

Source level adjustment (SLA) lets you adjust

the volume level of each source to prevent ra-

dical changes in volume when switching be-

tween sources.

! Settings are based on the FM volume level,

which remains unchanged.

1 Compare the FM volume level with the

level of the source you wish to adjust.

2 Use MULTI-CONTROL to select SLA in

the audio function menu.

Refer to Introduction of audio adjustments on

page 24.

3 Push MULTI-CONTROL up or down to

adjust the source volume.

Each time MULTI-CONTROL is pushed up or

down, source volume increases or decreases.

SLA +4 to SLA –4 is displayed as the source

volume is increased or decreased.

Notes

! The AM volume level can also be adjusted

with source level adjustments.

! The built-in CD player and the multi-CD player

are set to the same source level adjustment

volume automatically.

! External unit 1 and external unit 2 are set to

the same source level adjustment volume

automatically.

Audio Adjustments

En

27

English

Section

03

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 217 218

Comments to this Manuals

No comments