Pioneer PDP-428XG User Manual download pdf (Page 16)

Preparation

Preventing the plasma television from

falling over

After installing the stand, be sure to take special care to ensure

that the plasma television will not fall over and is stabilized to both

the wall and rack.

Stabilizing on a table or rack

Stabilize the plasma television as shown in the diagram using the

plastic bands and screws supplied with the optional stand.

Note

• To stabilize the plasma television on a table or rack, use screws

that have a nominal diameter of 4 mm and that are at least 20

mm long.

Caution

• A table or rack with adequate strength should always be used

to support the plasma television. Failure to do so could result

in personal injury and physical damage.

• When installing the plasma television, please take the

necessary safety measures to prevent it from falling or

overturning in case of emergencies, such as earthquakes, or of

accidents.

• If you do not take these precautions, the plasma television

could fall down and cause injury.

• The screws, hooks, cords and other fittings that you use to

secure the plasma television to prevent it from overturning will

vary according to the composition and thickness of the surface

to which it will be attached.

• Select the appropriate screws, hooks, cords, and other fittings

after first inspecting the surface carefully to determine its

thickness and composition and after consulting a professional

installer if necessary.

Using a wall for stabilization

1 Attach falling prevention bolts (hooks) to the plasma

television.

2 Use strong cords to stabilize it appropriately and firmly to

a wall, pillar, or other sturdy element.

Perform this work in the same way on the left and right sides.

Use hooks, cords and fittings that are available on the market.

Recommended hook: Nominal diameter 8 mm Length 12 mm to

18 mm.

Basic connections

Connecting the antenna

To enjoy a clearer picture, use an outdoor antenna. The following is

a brief explanation of the types of connections that are used for a

coaxial cable.

• Connect the 75-ohm coaxial cable (commercially available) to

the ANT IN (antenna input) terminal.

NITOR

OUT

SUB

WOOFE

20 mm min.

4 mm

8 mm to 15 mm

Screw

(M4 x 10 mm)

Wood screw

(commercially available,

4 mm x 20 mm min.)

Wood screw

Screw

Drill a hole in the

middle at the rear

of the tabletop

panel before using

a wood screw.

Perform this work

the same way on

the left and right

sides.

MONITOR

OUT

OOFE

12 mm to 18 mm

1. Hook

2. Cord

Fitting

MONITOR

OUT

SUB

WOOFER

Standard DIN45325 plug (IEC169-2)

75-ohm coaxial cable (round cable)

(commercially available)

(Rear view)

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 265 266

Comments to this Manuals

No comments

Pioneer PDP-428XG User Manual Page 16

Comments to this Manuals

Related products and manuals for Televisions Pioneer PDP-428XG