Pioneer DEH-P9800BT User Manual download pdf (Page 84)

3 Push MULTI-CONTROL left or right to

select stereo or monaural.

Push MULTI-CONTROL left to select monaural

and MONO appears in the display. Push

MULTI-CONTROL right to select stereo and

STEREO appears in the display.

Adjusting subwoofer settings

When the subwoofer output is on, you can ad-

just the cut-off frequency and the output level

of the subwoofer.

1 Use MULTI-CONTROL to select

Subwoofer2.

Subwoofer2 appears in the display.

# When the subwoofer output is on, you can se-

lect Subwoofer2.

2 Push MULTI-CONTROL left or right to

select cut-off frequency.

Each time MULTI-CONTROL is pushed left or

right, cut-off frequencies are selected in the

following order:

50—63—80—100—125—160—200 (Hz)

Only frequencies lower than those in the se-

lected range are outputted from the subwoo-

fer.

3 Push MULTI-CONTROL up or down to

adjust the output level of the subwoofer.

Each time MULTI-CONTROL is pushed up or

down, subwoofer level increases or decrease s.

+6 to – 24 is displayed as the level is increased

or decreased.

Adjusting low pass filter

attenuation slope

When the subwoofer output is on, you can ad-

just the continuity of sound between speaker

units.

1 Use MULTI-CONTROL to select

Subwoofer3.

Subwoofer3 appears in the display.

# When the subwoofer output is on, you can se-

lect Subwoofer3.

2 Push MULTI-CONTROL up or down to

select the phase of subwoofer output.

Push MULTI-CONTROL up to select normal

phase and

appears in the display. Push

MULTI-CONTROL down to select reverse

phase and

appears in the display.

3 Push MULTI-CONTROL left or right to

select slope.

Each time MULTI-CONTROL is pushed left or

right, slopes are selected in the following

order:

–18— –12— –6 (dB/oct.)

Note

When slope of subwoofer and high pass filter are

–12dB, and same cut-off frequency, the phase is

reversed 180 degrees at the cut-off frequency. In

this case, reversing the phase assures improved

sound continuity.

Using the high pass filter

When you do not want low sounds from the

subwoofer output frequency range to play

from the front or rear speakers, turn on the

HPF (high pass filter). Only frequencies higher

than those in the selected range are outputted

from the front or rear speakers.

Muting the speaker units (filters)

You can mute front and rear speaker units (fil-

ters) separately. When speaker units (filters)

are muted, no sound is outputted from those

speakers.

Audio Adjustments

En

84

Section

14

1 ... 83 84 85 ... 233

Comments to this Manuals

No comments