Pioneer DEH-P9800BT User Manual download pdf (Page 85)

! If you mute the selected speaker unit (fil-

ter), MUTE ON is displayed and no adjust-

ments are possible.

! Even if any speaker unit (filter) is muted,

you can adjust the parameters for other

speaker units (filters).

1 Use MULTI-CONTROL to select

Front HPF (or Rear HPF).

Front HPF (or Rear HPF) appears in the dis-

play.

2 Push and hold MULTI-CONTROL down

to mute the selected speaker unit (filter).

MUTE ON is displayed.

# To cancel the muting, push MULTI-CONTROL

up.

Setting the high pass filter for

front speakers

1 Use MULTI-CONTROL to select

Front HPF.

Front HPF appears in the display.

2 Push MULTI-CONTROL left or right to

select slope.

Each time MULTI-CONTROL is pushed left or

right, slopes are selected in the following

order:

–12— –6—Pass (0) (dB/oct.)

# If you set the slope to 0 dB/oct. (Pass), the

audio signal bypasses the filter, so the filter does

not have an effect.

3 Turn MULTI-CONTROL to select

Front HPF FREQ.

Front HPF FREQ. appears in the display.

4 Push MULTI-CONTROL left or right to

select cut-off frequency.

Each time MULTI-CONTROL is pushed left or

right, cut-off frequencies are selected in the

following order:

50—63—80—100—125—160—200 (Hz)

Only frequencies higher than those in the se-

lected range are output from the front speak-

ers.

5 Push MULTI-CONTROL up or down to

adjust the output level of the front speak-

ers.

Each time MULTI-CONTROL is pushed up or

down, the level of the front speakers increases

or decreases. 0 to –24 is displayed as the level

is increased or decreased.

Setting the high pass filter for

rear speakers

1 Use MULTI-CONTROL to select

Rear HPF.

Rear HPF appears in the display.

2 Push MULTI-CONTROL left or right to

select slope.

Each time MULTI-CONTROL is pushed left or

right, slopes are selected in the following

order:

–12— –6—Pass (0) (dB/oct.)

# If you set the slope to 0 dB/oct. (Pass), the

audio signal bypasses the filter, so the filter does

not have an effect.

3 Turn MULTI-CONTROL to select

Rear HPF FREQ.

Rear HPF FREQ. appears in the display.

4 Push MULTI-CONTROL left or right to

select cut-off frequency.

Each time MULTI-CONTROL is pushed left or

right, cut-off frequencies are selected in the

following order:

50—63—80—100—125—160—200 (Hz)

Only frequencies higher than those in the se-

lected range are output from the rear speak-

ers.

Audio Adjustments

En

85

English

Section

14

1 ... 84 85 86 ... 233

Comments to this Manuals

No comments