Pioneer PRV-9000 User Manual download pdf (Page 115)

PRV-9000 Operating Instructions

For detailed information on Dolby Digital output, please refer to Chapter 4:

GETTING STARTED, section 4.1.3 Setting the Digital Audio Output.

DTS Out:

There are four points to keep in mind when using DTS Out.

 Noise is output when playing a DTS disc with a non-DTS-compatible

amplifier.

 A DTS DVD-Video disc is missing analog audio output signals.

 When playing a DTS audio CD, noise comes through the analog port

although the DTS Out is OFF.

 To play a DTS audio CD, verify that Stereo is active. Use the AUDIO

button to adjust the setting if necessary.

96kHz PCM Out:

The default setting is 96kHz > 48kHz. For more information, refer to Chapter

4: GETTING STARTED, section 4.1.3 Setting the Digital Audio Output.

MPEG Out:

The default setting is MPEG > PCM. For information on this option, refer to

Chapter 4: GETTING STARTED, section 4.1.3 Setting the Digital Audio

Output.

Audio DRC:

When watching Dolby Digital DVDs at a low volume, lower level sounds may

drop out. This dropping also can affect low-level dialog. Switching ON Audio

DRC (Dynamic Range Control) can bring up the low sounds while controlling

the high peaks. The sound variations adjust to the recorded material.

The available settings have the following effects:

 ON – balances dynamics

 OFF – leaves original dynamics intact

 Max – ‘squashes’ dynamics

Audio DRC is ineffective when listening to a disc through the digital output if

the Dolby Digital Out option is set to Dolby Digital. Adjust the dynamic range

from the AV amplifier/receiver to correct this situation.

107

1 2 ... 110 111 112 113 114 115 116 117 118 119 120 ... 149 150

No comments

Pioneer PRV-9000 User Manual Page 115