Pioneer PRV-9000 User Manual download pdf (Page 92)

PRV-9000 Operating Instructions

5. Begin recording.

When recording from DV In/Out, the recorder automatically pauses

recording if the signal is missing or interrupted. For example, the

recorder pauses during blank sections of a digital camcorder tape.

Check the Audio In settings for External Audio, Dual Mono Recording and DV

Input when recording any sequence. Often audio errors are traced to

incorrect Audio In settings rather than to a failure of the device.

Note: If the source material is copy-guarded, the recorder ignores the request.

6.3.2 Record From A Digital Camcorder

Before recording from a digital camcorder, set the audio input for the DV

IN/OUT. Use the recorder’s remote to control both devices.

Refer to the following information when recording from a digital camcorder:

 source signal must be in the DVS-SD format

 verify that your camcorder accepts commands from the recorder’s

remote

 a PRV-9000 DVD recorder cannot

control a second PRV-9000 (added

with a DV cable)

 the recorder ignores commands sent remotely through a component

connected to the DV IN/OUT port

 the recorder ignores commands to duplicate copy-protected material but

does play back the protected data

 date and time information from a DV cassette is non-transferable

To record material from a digital camcorder, follow the directions below.

1. Connect the digital camcorder to the front panel DV IN/OUT port.

2. Verify that the camcorder is set to video transfer (VTR) mode.

3. Set recording features.

 MN1 thought MN 8 is unavailable when recording from DV IN/OUT

 Audio is 2ch Dolby Digital when recording from DV IN/OUT

4. Check the DV audio input settings.

 Choose between Stereo1 (original audio) and Stereo2 (overdub)

 Set the DV Input from the Initial Setup menu, sub-menu Audio In

 Verify your settings for Audio In (External & Dual-Mono Recording)

1 2 ... 87 88 89 90 91 92 93 94 95 96 97 ... 149 150

No comments

Pioneer PRV-9000 User Manual Page 92